VWDiesel.net The IDI, TDI, and mTDI source.
Engine Specific Info and Questions => IDI Engine => Topic started by: b1rdjx88 on April 24, 2007, 10:57:46 am
-
Could someone explain the differences between the flywheels that come in Mk3s? I understand there were versions available with either one or two alignment dowel pins and that the ones made in Mexico may be different?
I need to replace my clutch and I am not sure which pressure plate to order. I see two kits available for a 1994 aaz at autopartsonlinecanada.com,and one kit specifies: "210mm Flywheel must be changed if vehicle is equipped with a LUK flywheel made in Mexico. (http://parts.autopartsonlinecanada.com/parts/apocanada/wizard.jsp?year=1994&make=VW&model=GOL-D-004&category=I&part=Clutch+Kit&appChassis=-038600)"
Recently, when reassembling my engine I noticed my flywheel has only one dowel pin, but the pressure plate has two notches... I found this out when I tried to install my timing belt and realized the timing mark was off!:x
Thanks,
Alan