VWDiesel.net The IDI, TDI, and mTDI source.

Engine Specific Info and Questions => IDI Engine => Topic started by: wolf_walker on July 09, 2012, 10:31:17 am

Title: Ideas on PCV for NA-AAZ?
Post by: wolf_walker on July 09, 2012, 10:31:17 am

(http://img823.imageshack.us/img823/1883/imag1985.th.jpg) (http://imageshack.us/photo/my-images/823/imag1985.jpg/)
(http://img521.imageshack.us/img521/7215/imag1984.th.jpg) (http://imageshack.us/photo/my-images/521/imag1984.jpg/)
(http://img593.imageshack.us/img593/8404/imag1977.th.jpg) (http://imageshack.us/photo/my-images/593/imag1977.jpg/)
(http://img838.imageshack.us/img838/3672/imag1958.th.jpg) (http://imageshack.us/photo/my-images/838/imag1958.jpg/)


So I've got a NA intake with the two half inch hose barbs, I've got an AAZ valve cover with the flat-ish oil sperator and an almost 1" nipple on it.
You can see the unsightly way it was plumbed with the huge brass fitting and a lot of hose clamps and a big wide bend of that 3/4 heater hose to the
oil separator.  There has got to be a better way...    Thoughts?
I am without my shop and boxes of spare hoses and fittings and junk I usually go to for cobbling stuff together unfortunately so I've got to buy something
or just use this junk till I get back to turbo land.

Title: Re: Ideas on PCV for NA-AAZ?
Post by: R.O.R-2.0 on July 09, 2012, 11:32:30 am

look into the 1Y PCV setup..