VWDiesel.net The IDI, TDI, and mTDI source.
Engine Specific Info and Questions => IDI Engine => Topic started by: kaneb on January 09, 2010, 10:31:45 am
-
Hi-
So i'm at the the point where i'm de-glazing/honing the block. The cylinders look great just are a bit glazed, im just honing it to de-glaze it. Just a quick run through with the hone. My question is i don't have a cylinder bore gauge, and im ordering my bearings and rings today. For just a quick deglaze, not an actual hone from a machine shop i won't need the oversize rings will i? I was just going to get standard. Is that a problem..or should i say turn into a problem, i dont want to be one of those horror stories when i have excessive blow by because my rings aren't the correct ones? Or what do you others usually do? This is my first vw rebuild. Im used to the big bore engines with cyl. sleeves.
Any help is appreciated as i would like to order these parts today so i can start assembly soon.
TIA--Kane
-
Do you know if the cylinders are already up to spec? If so, then just deglazing will not affect anything as you are only supposed to run the tool for 30 seconds or so. If they are out of spec, then it'll smoke anyways.
-
If you hone it enough to need new rings you'll also need new pistons, that said if it's within specs then honing won't get it out of spec.......unless you way over do it ;D
-
ok, i thought it would be fine, but thought i would ask to reassure myself haha. Kobleshimt (SP?) bearing ordered and some good rings. Ya. Ill update my build thread once i get some more stuff happening.
But for now this thread can die i got my answer. Thanks guys!
-
I'll be watching your build Kane since I'll likely be doing the same with mine :)
-
Ill be looking forward to your 1.9l as well!