Author Topic: Blow apart diagram of aneroid pin asembly (Read 3532 times)

Cheesetoast · « **on:** May 25, 2007, 11:20:54 pm »

i'd like as many pictures of this as i can, i want to make absolutely sure it's back in there right. is it ok to use the small shorter spring? advantages? i need to know what if any washers go where, the one i replaced mine with was slightly different.

Cheesetoast · « **Reply #1 on:** May 25, 2007, 11:30:35 pm »

the 1.9 pin that was in there had this metal washer, the 1.6 one didn't, i used the shorter spring and this washer. good?

Cheesetoast · « **Reply #2 on:** May 25, 2007, 11:52:24 pm »

do i need this o-ring/gasket?

zagarus · « **Reply #3 on:** May 26, 2007, 12:20:59 am »

u need to use the macro feature on your camera lol :lol:

but i hear you can use the 1.6 pin in place of the 1.9

Cheesetoast · « **Reply #4 on:** May 26, 2007, 01:31:12 am »

that is hte macro feature..... really old canon a40

zaprzal · « **Reply #5 on:** May 26, 2007, 01:50:59 am »

look at your pin and you will know if you need washer

Quote

that is hte macro feature..... really old canon a40

canon a40 can make good makro

jimfoo · « **Reply #6 on:** May 26, 2007, 05:44:51 am »

Quote from: Cheesetoast

the 1.9 pin that was in there had this metal washer, the 1.6 one didn't, i used the shorter spring and this washer. good?

Dude! That's my pin. It was slready like that when I bought it. So if other diesels have VE pumps, are there other pumps that have pins like the 1.6, that will fit our pumps?

Cheesetoast · « **Reply #7 on:** May 26, 2007, 09:12:15 am »

Quote from: "zaprzal"

look at your pin and you will know if you need washer

um, huh? so if it's the 1.6 pin like that i should use the washer?