Gm Nozzel? - IDI Engine - VWDiesel.net The IDI, TDI, and mTDI source.

• Gm Nozzel? by vw2k2000 on 05 Jan, 2010 06:12
• Anyone know if a GM 6.2 nozzel =DNOSD#248 or #304 will work well in a 1.6 IDI?  Thanks
• #1 by Rabbit on Roids on 05 Jan, 2010 07:41
• it will probably work, but the nozzle is not going to be matched very well to the pre cup.
• #2 by truckinwagen on 05 Jan, 2010 10:21
• I run them(mostly because they are cheaper) and see no difference in performance at all
• #3 by rs899 on 05 Jan, 2010 11:51
• I just bought a set of the proper Bosch VW IDI nozzles for less than $11ea at Euro Parts Direct ($50 free ship).  Are the GM nozzles that much less?
  
  Rick
• #4 by truckinwagen on 05 Jan, 2010 11:56
• I got them locally for $5 each.
• #5 by tindias on 05 Jan, 2010 13:03
• I know the 300D nozzles fit, some say they have a higher flow rate...anyone tested this?
• #6 by OM617 on 05 Jan, 2010 19:02
• Mercedes nozzles are for a very different prechamber design. The VW precup has no way to atomize the fuel like the MB prechamber's ball does.
• #7 by rs899 on 06 Jan, 2010 03:53
• I thought $11/nozzle is cheap enough for VW ones.  I would like to try running VW nozzles in my OM616- MB nozzles are closer to $30 ea....
  
  Rick
• #8 by vanbcguy on 06 Jan, 2010 10:51
• Quote from: tindias on 05 Jan, 2010 13:03

  I know the 300D nozzles fit, some say they have a higher flow rate...anyone tested this?
  

  
  Pretty sure a few people on here have tried out the Merc nozzles.  Results were lots of smoke and in one case blown out precups... not a good combo!