VWDiesel.net The IDI, TDI, and mTDI source.

General Information => Upgrades (non engine related ) => Topic started by: fdnyguy on May 17, 2007, 08:01:10 am

Title: Jetta seats.
Post by: fdnyguy on May 17, 2007, 08:01:10 am

Seeing the vast knowledge of VW's on here, does anyone see a problem putting 04 jetta seats in an 89? Have the seats and the tracks, width doesn't seem to be a problem. I only see the possibility that the holes holding the support bolts in wont line up. Obviously not a big deal, right?

Seats have airbags, obviously disconnected. not worried about that.

If I missed anything or am incorrect, advice is of course appreciated.

Thank you, be safe.....

Title: Jetta seats.
Post by: burn_your_money on May 17, 2007, 03:23:58 pm

As long as you can still shift and close the doors I'd put them in. I'd imagine it will require a welder

Title: Jetta seats.
Post by: jtanguay on May 26, 2007, 06:13:47 am

hmmm are the seats electrical??? that would be a cool upgrade...  8)

Title: Jetta seats.
Post by: BlackTieTD on May 26, 2007, 08:01:37 am

i dont think the tracks are the same mkII to mkIV. mkIV should be wider and different in a few other ways. mkI/mkII swap no problem..

Quote from: "jtanguay"

hmmm are the seats electrical??? that would be a cool upgrade...  8)

install MORE electrical problems?!?!  :lol:

Title: Jetta seats.
Post by: mainer on May 26, 2007, 03:21:19 pm

you might be able to switch the bases. I know to go from mk3 to mk2 you can just swtich the bases. But I've never had a mk4 seat apart.
_________________
Mercedes 400 (http://www.mercedes-wiki.com/wiki/Mercedes-Benz_400)