VWDiesel.net The IDI, TDI, and mTDI source.

Engine Specific Info and Questions => IDI Engine => Topic started by: regcheeseman on August 15, 2006, 08:31:58 am

Title: what size banjo's on the KKK turbo?
Post by: regcheeseman on August 15, 2006, 08:31:58 am

Anyone know what size the banjo fittings are on the KKK's, I want to make up some lines for boost controller/ gauge

Title: what size banjo's on the KKK turbo?
Post by: zooky on August 15, 2006, 06:09:13 pm

no idea.
But when I was at the bone yard I noticed that the gasser VW's used some nice braided stainless steel lines that looked like the same banjo...

Title: what size banjo's on the KKK turbo?
Post by: hillfolk'r on August 15, 2006, 07:25:33 pm

i wanna say 10mm,but the thread picth,,i dunno

Title: what size banjo's on the KKK turbo?
Post by: LeeG on August 15, 2006, 10:19:42 pm

My spare K24 has 8mm x 1.00 pitch.  
Banjo on the compressor housing, straight through pipe type fitting on wastegate.  Same thread both ends, wastegate end looks like maybe it should have a washer under for seal, but my spare does not.

Title: what size banjo's on the KKK turbo?
Post by: fspGTD on August 21, 2006, 10:13:34 pm

CIS fuel banjos (like to the cold start fuel injector) fit perfectly. :)

Title: what size banjo's on the KKK turbo?
Post by: hillfolk'r on August 21, 2006, 11:14:27 pm

doyou have the stock pipe on the turbo for the wastegate? you just cut it like mine
(http://img206.imageshack.us/img206/6461/hpim0454nk5.jpg)
(http://img64.imageshack.us/img64/8472/hpim0447sg9.jpg)