VWDiesel.net The IDI, TDI, and mTDI source.

For Sale/Looking For => Parts for Sale/Wanted => Topic started by: bryanbryan89x on August 13, 2006, 02:25:24 pm

Title: WTB: 100mm Driveshafts
Post by: bryanbryan89x on August 13, 2006, 02:25:24 pm

Need a set of 100mm drive shafts to fit my FN tranny

Title: WTB: 100mm Driveshafts
Post by: vwmike on August 13, 2006, 08:45:27 pm

An FN and 100mm axles don't mix.

Title: WTB: 100mm Driveshafts
Post by: bryanbryan89x on August 14, 2006, 04:01:45 am

Actually i just went out and measured it and it came out to 4 inch approx, 100mm.

Title: WTB: 100mm Driveshafts
Post by: vwmike on August 15, 2006, 03:26:14 am

perhaps it is measured differently, but an FN is an early long ratio gearbox with an open differential. 100mm cups came on later cars using a minislip differential so the seals and whatnot are different.

Title: WTB: 100mm Driveshafts
Post by: RabbitGTDguy on August 15, 2006, 04:02:01 am

yes, I have an FN on my car right now and unless someone has swapped out the cups on the tranny itself it should be a 90mm driveshaft you need...
If thats the case let me know as I have two really good driveshafts here that are new within the last two years with less than 20k on them....

Joe