VWDiesel.net The IDI, TDI, and mTDI source.
Engine Specific Info and Questions => IDI Engine => Topic started by: Ian0391 on April 13, 2015, 12:39:04 pm
-
Hey guys, I just finished swapping and aaz into diesel mk2. The motor last ran about a year ago, it has a fresh timing belt on it and the motor spins free. I'm about to start it up for the first time, is Th ere anything special I should do to prep it first?
Also it seems like it's sitting in the car a little crooked, like the valve cover is lower on the right vs left. Is that fine?
-
I've heard of putting a few drops of oil down the valves to help lubricate the cylinders but other then that and an oil change I can't think of much.
-
change oil/filter; air filter, check all intake &connections, clean; fuel filter, prime from inlet. check that water/coolant is good. as long as you have fuel @fuel pump you should be ok; good batt; i guess your ready to crank over; if she starts up let idle,(if you have turbo), its not a bad idea to let idle for 1-2mins, the rev up some and get her warm, after a few mins take for a drive; if everythings in order otherwise. i d throw in lubromoloy + seafoam to a full tank. as far as the motor sitting crooked it may be a problem, mounts and drivetrain may bind, ?needs new motor mounts?.
-
The engine doesn't sit straight side to side in these cars. :)
-
I'm glad to hear they re supposed to be a bit crooked. As far as all the filters fuel and accessories, I just swapped out a running but worn out 1.6 for the aaz so it's all fresh and working, and all the fluids have been changed so I guess I'm good to go, thanks for the help