VWDiesel.net The IDI, TDI, and mTDI source.

Engine Specific Info and Questions => IDI Engine => Topic started by: sethyboy85 on March 26, 2006, 07:28:35 pm

Title: ASF, AON, ACN, ACL (8v) bolt to my 1.6l diesel?
Post by: sethyboy85 on March 26, 2006, 07:28:35 pm

just that simple would a ASF, AON, ACN, ACL (8v) tranny bolt to my diesel?

Title: ASF, AON, ACN, ACL (8v) bolt to my 1.6l diesel?
Post by: X@V on March 26, 2006, 08:03:20 pm

They will bolt.

The ratios are different.

http://cars.vwsport.com/gears/index.html

Title: ASF, AON, ACN, ACL (8v) bolt to my 1.6l diesel?
Post by: Maarten on March 27, 2006, 04:48:05 am

bolt yes... but clutch/pressureplate/flywheel are needed too, the shaft is thicker and has more splines on it.

And the drivesaxles have 100mm CV joints instead of the 90mm, so you need those too.

Title: ASF, AON, ACN, ACL (8v) bolt to my 1.6l diesel?
Post by: sethyboy85 on March 27, 2006, 05:23:27 am

Quote from: "X@V"

They will bolt.

The ratios are different.

http://cars.vwsport.com/gears/index.html

yes I know I want a longer geared tranny. clutch/flywheel are no big deal

both sites that I have seen are conflicting saying that a ACN and ASF are 90mm and 100mm (different years I guess)

does a 100mm use the same outer knuckle or would I need those as well off of a car.

Title: ASF, AON, ACN, ACL (8v) bolt to my 1.6l diesel?
Post by: wyldman on March 27, 2006, 07:19:16 pm

All you have to worry about is the flange size,the outer ends are the same.

It's not hard to swap flanges if you need to.

Title: ASF, AON, ACN, ACL (8v) bolt to my 1.6l diesel?
Post by: dubCanuck1 on March 27, 2006, 08:55:39 pm

I've got two ACN's. One's a 100mm and the other's a 90mm. Go figure.