VWDiesel.net The IDI, TDI, and mTDI source.

General Information => General => Topic started by: theman53 on October 28, 2013, 07:11:30 am

Title: power steering pumps in MK2 and MKIV
Post by: theman53 on October 28, 2013, 07:11:30 am

From what I can see both have an m16-1.5 threaded port...in theory I am wanting to see if the lines could be bolted onto either pump. The Jeep Wrangler I am working on the pump lines for its power steering will bolt onto the MKIV as I have seen it on another guys build. I have a PS pump from a MK2 and don't want to buy anymore if I don't have to. Also I don't want to make a bracket for the Jeep pump to fit on the VW engine.

Title: Re: power steering pumps in MK2 and MKIV
Post by: CRSMP5 on October 28, 2013, 11:17:51 am

mk4 pump and bracket in different place then mk3 and mk2...

for bbob's we used mk3 set up on his mk2/b3... feed line was direct swap even though one was banjo vs threaded line..

Title: Re: power steering pumps in MK2 and MKIV
Post by: bbob203 on October 28, 2013, 01:49:50 pm

the fitting for the banjo vs pressure fitting is just and adpater. banjo uses no adapter.

Title: Re: power steering pumps in MK2 and MKIV
Post by: CRSMP5 on October 28, 2013, 01:55:15 pm

 ???

direct swap on yours.. did not have to change anything bbob...

Title: Re: power steering pumps in MK2 and MKIV
Post by: theman53 on October 28, 2013, 05:11:42 pm

The position of the bracket I don't care, I just need to know if it was possible to attach the lines from a MKIV to a MK2 pump.