VWDiesel.net The IDI, TDI, and mTDI source.

Engine Specific Info and Questions => IDI Engine => Topic started by: Gator79 on May 25, 2013, 09:33:31 pm

Title: Injection pump bracket.
Post by: Gator79 on May 25, 2013, 09:33:31 pm

Will a mk2 pump bracket work in a mk1 along with a gasser pass side motor mount?

Title: Re: Injection pump bracket.
Post by: burn_your_money on May 27, 2013, 06:20:18 am

I think you would want a MK3 AAZ or AHU/1Z TDI with the 50mm hole (1 piece pulley).
The MK2 uses a very similar support for the pump mount as the MK1. The only difference is there is no motor mount attached to it.
I'm not sure if there are 3 mounting points on the mk2 block for the mk3 bracket though. If I remember I'll have a look next time I'm in the shop.

Title: Re: Injection pump bracket.
Post by: fatmobile on May 30, 2013, 12:56:25 am

 You mean weld the gasser bushing holder onto the diesel bracket?

Title: Re: Injection pump bracket.
Post by: burn_your_money on May 30, 2013, 06:55:43 am

I think I've seen someone cut the pump bracket and then use the gasser motor mount as well. I'm not overly excited about that idea though.