VWDiesel.net The IDI, TDI, and mTDI source.
General Information => Troubleshooting => Topic started by: Golf/Jetta on July 09, 2011, 07:27:56 pm
-
I’ve been poking around over several site and no one seems to (even the book) talk about play on the main input shaft on a 020 transmission nearest to the clutch/engine.
I do know play is bad but how much play is tolerated?
Watch the play on this shaft at YouTube (http://www.youtube.com/watch?v=CH4ZuvVzLzg&feature=autoplay&list=PLBCE3D2E811F15F3C&index=13&playnext=2)
-
I would pm "Broke" on the vwvortex. He is very helpful and is an expert on 020's.
-
I didn't see any play in that shaft, what movie were you trying to show?
-
I didn't see any play in that shaft, what movie were you trying to show?
This. Perhaps you posted the wrong video? Cause thats not an 020..
-
Maybe it was this one he meant...?
http://www.youtube.com/watch?v=e9qfLpQGb1k&NR=1 (http://www.youtube.com/watch?v=e9qfLpQGb1k&NR=1)
-
Yikes, if that's the one he meant then that is definitely too much play!!! :o There's probably no bearing left to speak of.
-
Umm not exactly. On the beetle tranny that is shown, there is a pilot bearing. This stabilises the input shaft to compensate for play. Not uncommon at all to see that much play in a perfectly fine tranny.