VWDiesel.net The IDI, TDI, and mTDI source.
General Information => Upgrades (non engine related ) => Topic started by: Fredrikkk on June 02, 2011, 08:06:51 am
-
I've found some nice rims that are made for a Peugeot with ET13 and 4x108. I can't use adapters so I wondered if Audi wheel hubs and discs will fit since they are 4x108. Anyone know this?
:)
-
pretty positive that they wont work.. fronts or rears.
someone else can confirm tho. it was a long time ago when i was reading about it..
-
Anybody else know? I really need to know :-\
-
give it a go here
http://forums.vwvortex.com/forumdisplay.php?5003-Technical-%28VW-Audi%29
i can't figure out what area this fits in specifically, but you're best answer would be found here.
-
ive never seen or heard of a conversion, so i doubt it works. why cant you just buy adapters? they make them..
-
I can't use adapter because I'd end up at like -ET 7 and that's too much I think at stock ride height. Or could I make it stay under the fenders with the arch trim glued a little out?
-
mk2s have LOTS of room in the fender wells..
wheel adapters are not very thick. you want adapters.. not adapters/spacers..
-
The thinnest adapter I can find is 20mm.
But you're saying ET -7 will be fine at stock ride height?
-
idk what et -7 is, compared to something else..
i know that i have way oversized tires on my mk2, and they only rub ever so slightly, and only at certain spots. conditions have to be just right..