VWDiesel.net The IDI, TDI, and mTDI source.

Engine Specific Info and Questions => IDI Engine => Topic started by: jpedro on February 03, 2011, 02:51:47 pm

Title: Front bumper removal
Post by: jpedro on February 03, 2011, 02:51:47 pm

how do you remove the front bumper cover, im trying to figuree it out but i cannt seem to get it out? any suggestions its a 1990 jetta

Title: Re: Front bumper removal
Post by: rodpaslow on February 03, 2011, 03:56:53 pm

You need to remove the complete bumper if you haven't.  If it's an aftermarket one there will be a few screws and plastic clips holding it on.  An original vw one I think is just clipped on, not 100% sure of that.  But it will be easy to see once you have the bumper off.  Two bolts on each side of the front crossmember from below the car and one horizontally in from the side.  These are a bit harder to get at from underneath.