VWDiesel.net The IDI, TDI, and mTDI source.
General Information => General => Topic started by: b1rdjx88 on November 12, 2008, 09:19:55 am
-
Could anyone recommend a good auto machine shop in Ottawa?
I have an aaz that I would like to get some work done on.
-Bore/hone block
-resurface head
-install 4 new valve guides
-grind crank main journals
-tdi repair on crank nose
I expect most places from the yellowpages would be fine for the block/crank work, I'm just nervous about the head.
-
Thought I would update this thread in case anyone stumbles across this in the archives.
I had the crank machined for tdi pulley and polished by a guy in Manotick. He did a great job and had it done the next day.
I dropped the block off at Bells Corners Machine Shop in Nepean. They told me it would be cleaned up and micced in a couple days and they would have it bored within two weeks. Three weeks later they still hadn't touched it. It was finally finished 6 weeks after I dropped it off.
I took the head into Hodge's Service Center on Bronson Ave. Dave who runs their machine shop seems good. He is doing a full resurfacing with the precups removed and valve job. I dropped it off last week and I should have it back this week. I also had him order some total seal rings for me :D