VWDiesel.net The IDI, TDI, and mTDI source.
Engine Specific Info and Questions => IDI Engine => Topic started by: ShoulderMan on October 22, 2008, 01:37:31 pm
-
Does anyone know if this will fit on the 1.6l Diesel?
www.eurospecsport.com/products/components/main-bearing-girdles.htm
Part# 049-198-601-mbg
Thanks
-Ron
-
Why?
The bottom end isnt the weak link here.
I mean it's cool and all but for $500.00 you could have ALL your internal parts paid for.
-
Never hurts to have too much insurance. I figure if im going to rebuild the block from top to bottom, and turbo it, it cant hurt.
I should beable to pick that up for about $100 less.
What is or where is the weak link in the 1.6l?
-
yea.. unless you plan on going above 200 whp, the bottom end holds up real well. instead buy some ARP main & rod studs for a fraction of the cost (it will reduce power robbing flex)
andy2 made a main girdle for his 1.9 beast. if you search hard enough you can find it. it's under his compound thread.
-
it looks as if thoes pictures have expired.
would have been nice to have seen.
seems the head is the weakest link.
-
Did you notice the Eurospec Main Bearing Girdles is for I-4 with chain driven oil pumps. Our IDI VW's are not chain driven. Are the TDI flavors ?
-
Ah, I must have been up too late with the project :-D
-
aren't some of the new PD/CR engines chain driven oil pumps??? or driven off a gear of the crank?
-
Later TDIs are with chain oil pumps.
My girdle (http://www.kotinet.com/matti.farm/Scirocco/Moottori/IMG_2594.jpg)