VWDiesel.net The IDI, TDI, and mTDI source.

Engine Specific Info and Questions => IDI Engine => Topic started by: allsierra123 on October 02, 2008, 04:10:12 pm

Title: Anyone make an EGR block off plate?
Post by: allsierra123 on October 02, 2008, 04:10:12 pm

Or is it something I will need to come up with?

Title: Anyone make an EGR block off plate?
Post by: jtanguay on October 02, 2008, 04:17:27 pm

you could check out kerma TDI.

it's not too hard to make though... just get a piece of steel and cut it then drill some holes, and bingo.  you can use the egr line as a template even.

Title: Anyone make an EGR block off plate?
Post by: allsierra123 on October 02, 2008, 04:25:01 pm

Nice. Wastn sure if it had to be anything special or not.

Title: Anyone make an EGR block off plate?
Post by: blkboostedtruck on October 02, 2008, 06:50:17 pm

i might have one? i bought an intake that had one but i welded up the hole because i needed more clearance but i still have the plate left!
Duane

Title: Anyone make an EGR block off plate?
Post by: blunt on October 05, 2008, 03:19:27 pm

I used a bit of 5mm deep flat bar, cut it to match the shape of the flanges on the egr i removed, drilled it and bolted it straight on to place, piece of cake!

Title: Anyone make an EGR block off plate?
Post by: commuter boy on October 05, 2008, 11:40:57 pm

Piece of sheet metal for me.  Cut it with some tin snips, filed the edges, drilled a pair of holes and in it went.