VWDiesel.net The IDI, TDI, and mTDI source.
For Sale/Looking For => Parts for Sale/Wanted => Topic started by: stewardc on September 12, 2008, 08:59:36 am
-
210mm Slightly used. Very agressive - you won't slip this one.
Make me an offer.
(http://img.photobucket.com/albums/v648/stewardc/100_4758.jpg)
-
DAMN!
If this was a 6 puck....
What spline is it?
-
It's for a standard, common 020 tranny (1991 Jetta)
-
Man I'll bet that baby HOLDS!!!!!!
-
I rode in a MK II with that setup...it holds like an on/off switch. (AND IT HOLDS).
-
hey stew!
I'll take that ! i need one to replace the one i got burned on! the spline on the one i got is too big i still don't know what it fits? but the clutch was right!
whats the going rate for one of those? i paid 40bucks for that last one i got!
P.M. me what you have in mind?
Duane
-
hey stew!
I'll take that ! i need one to replace the one i got burned on! the spline on the one i got is too big i still don't know what it fits? but the clutch was right!
Duane
I'd say the one you have is for a 16V trans then.
-
hey stew!
I'll take that ! i need one to replace the one i got burned on! the spline on the one i got is too big i still don't know what it fits? but the clutch was right!
Duane
I'd say the one you have is for a 16V trans then.
i don't think the 16valve trans has a bigger input shaft?
thier all the same i'm sure!
Duane
-
The 16V/ 2.0 ABA trany has a bigger shaft than the 8V trany.
-
How much mailed to sw ontario? N0P 1C0. I'll put a check in the mail, or Post office money order if you prefer......
Does it work with a standard pressure plate?
-
Sorry, but it's sold.
Thanks guys.