VWDiesel.net The IDI, TDI, and mTDI source.

Engine Specific Info and Questions => IDI Engine => Topic started by: Justin on May 26, 2005, 02:26:52 pm

Title: Would this turbo work???????
Post by: Justin on May 26, 2005, 02:26:52 pm

what do you guys think of this turbo to put on a 1.6 Diesel? its an IHI turbo serial # RHF4, and here is the link to the specs for it, I can probably pick it up for free and I would build the 1.6 to compliment the turbo.

http://www.ihi-turbo.com/turbo_RHE-RHF.htm

Let me know what you think, thanks guys
later
justin

Title: Would this turbo work???????
Post by: Justin on May 27, 2005, 07:28:32 am

bump

Title: Would this turbo work???????
Post by: DVST8R on May 27, 2005, 08:59:03 am

At first I thought it was light in the flow department, and then I realised that it was in m3/min not lbs/min. After a little looking and calculating I think that for a free turbo I would run it. Not a huge PR, but good flow, being that it is ball bearing it should spool up well too.

Title: Would this turbo work???????
Post by: Justin on May 29, 2005, 03:02:53 pm

DVST8R,

What Calculations did you use to figure out that this turbo would probably do the trick,  and what is PR?

Thanks for your help

Later
Justin

Title: Would this turbo work???????
Post by: DVST8R on May 29, 2005, 10:30:10 pm

maximum PR is 2.7 as stated by the web site you gave. The calculation I did was change m3/min to lbs/min. Then I took the map and compared it to the stock kkk map, and the stock garret map (well a close one anyway) and extraplated from there. Also if you look on the website that you listed it has a recomended diesel HP rating range of 46-130. Fine for most 1.6TD's. If you need any more turbo info I would highly recomend the books "maximum boost" by corky bell, and "turbochargers" by hugh macinnes. Chapters has a 30% off sale on right now and both of these books qualify. :wink: