VWDiesel.net The IDI, TDI, and mTDI source.

Engine Specific Info and Questions => IDI Engine => Topic started by: saurkraut on April 16, 2008, 05:24:11 am

Title: K14 turbine and K24 compressor?
Post by: saurkraut on April 16, 2008, 05:24:11 am

Can a K14 hot side and bearing housing accept a K24 kompressor?

Title: K14 turbine and K24 compressor?
Post by: Han Solo on April 16, 2008, 02:36:28 pm

:lol: i was thinking about the same question but with a t2 and t3

Title: K14 turbine and K24 compressor?
Post by: Luckypabst on April 16, 2008, 04:03:56 pm

I'm gonna go out on a limb and say no, it won't be a simple mix'n'match of parts. The turbine shaft is of a larger diameter on the K24 and the center section is larger as well, so the compressor backing plate won't just bolt up.

With access to a machine shop, I'm sure it would be possible - maybe not cost-effective.

Chris