VWDiesel.net The IDI, TDI, and mTDI source.

General Information => General => Topic started by: jimfoo on January 18, 2008, 09:03:53 am

Title: bending injection lines
Post by: jimfoo on January 18, 2008, 09:03:53 am

Ok, I know you aren't supposed to do it, but who has, and who has had problems afterwards? ALH lines are plentiful, AHUs are not, which is what I need. While I can see tight bends causing problems, I really don't see how a gentle bend could do anything.

Title: bending injection lines
Post by: jtanguay on January 18, 2008, 03:03:07 pm

i would imagine there to be a 'coating' if waste veg was used constantly and then no purge  :lol:.  i would heat the metal before bending though...

as long as the injector lines retain the same length you should be fine.