VWDiesel.net The IDI, TDI, and mTDI source.
General Information => Upgrades (non engine related ) => Topic started by: subsonic on October 13, 2007, 10:48:52 pm
-
OK, I am 6'4". I only wear a 33-34" length pants. I have a long body. Is there any way to lower the driver seat an inch or two? I have no sunroof so I am at maximum roof height right now. I fit, but it's tight. Kind of need to crank back the seat low rider style.
So short of welding a half dome over the drivers side, any suggestions??
-
scirocco and corrado seats are a direct fit (the adjuster might need messing with but the slider and secure pin will all work)....and they are height adjustable. and have much better bolsters.
-
Yep Corrado seats work well! I used a set in my caddy and it gave me more head room!
thanks Duane
-
I did not know that. Thanks.
GO
PATS!!
-
Most mk2 seats have the height adjustment as well.
You are basically the exact same height / leg length as me Jim and I didn't have any problems in my 92 jetta with stock seats.
-
My seats are not height adjustable. Front back and tilt. thats it. They are stock Golf GL seats, vintage '85. Nice shape, not a tear in them.
I fit, but like I said it's a bit tight. :shock: :lol: Wife was reading over my shoulder on that one. She smirked and gave me a pinch. :lol:
When I get out of the car I almost always end up with my hair squished flat on top. Kind of gives me the nice block head look. :)
-
When I get out of the car I almost always end up with my hair squished flat on top. Kind of gives me the nice block head look. :)
Pictures? :lol:
-
you can also use a height adjust base, and cover it with your current seat material if you have a nice all-matching interior.
-
you can also use a height adjust base, and cover it with your current seat material if you have a nice all-matching interior.
Yeah. It's not too bad to do. I do this mod on all the Rabbit's that I sell. I'm a big guy too, and I drive the cars I sell before they go. In an effort to keep the stock look, but add a bit of legroom, I pull the bases off of 1985-1988 Wolfsburg Jettas with the adjust lever.
Swapping the lower cushion cover takes about 1/2 hour. If you use Jetta bases, you'll have to pull the cover off the original lower foam and swap. Then reassemble.
Good Luck