VWDiesel.net The IDI, TDI, and mTDI source.
General Information => Upgrades (non engine related ) => Topic started by: theman53 on May 16, 2010, 05:10:24 pm
-
http://www.kayakwesty.com/jettahtrcore.html (http://www.kayakwesty.com/jettahtrcore.html)
I am thinking of using these. There is no mention of what the adhesive is or what it will take heat wise. I also don't know what the temp will be in the heater box. I assume that it will be whatever temp the coolant is - a couple degrees for heat loss in the hoses to get there. Anyone know what will work as an adhesive if this isn't up to the job?
-
I have some aerospace foam .125 ( 1/8 ) thick -50 to +350 with a acyrlic backing ( sticky )
send your size and address
GB
-
I used them, made it through one winter so far. Clean the metal well first (I used brake clean). It also helps to wrap it around far enough that the material sticks to itself where the holes in the metal plate are located.