VWDiesel.net The IDI, TDI, and mTDI source.
»
General Information
» Troubleshooting
View full version:
Troubleshooting
«
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
»
Timing belt tensioner pulley for 1994 AAZ
New engine and subframe and a serious sounding knock noise
Good Deal on Tires?
1.6L IP Pushing fuel out Inlet Banjo
Cold Start Problem
Trying to put in new plunger/head seal(?) on the IP.
misses and white smoke if i
Loud ticking/tapping/knocking from 1.6 IDI 81 jetta
a test for diesel guru's
Oil Pressure Gauge not zero'd
Caddy 1.6d na glow plugs
Not so Good Vibrations
wipers quit working out of nowhere
IP Pulley position
Possible Headgasket/who knows
Hanging rpm after hardline change - IDI
brand new here. and with vw diesels. need some help
no picture, oil galley plug on belt side of head WELDED UP
No start....battery issue?
Sudden and shortlived knocking
Need help id'ing radiator wires
dont know where to post, making a flywheel adapter to run generator
Head gasket input?!
Wrong oil pressure sender?
This one'll stump you all.......
Where do I find the fusible link on a '96 golf????
82 caddy 1.6 N/A low idle for the first 10 to 15 seconds
AC compressor not tripping?! MKIII AAZ.
how do you remove alternator? I've searched but can't find.
Starting issue when engine is at operating temp.
how to adjust smoke screw
Missing Main Bearing Cap-any remedy?
Leaking Hard Lines at Delivery Valves
No power at the little wire on the starter
Cold start handle stiff/stuck (not due to bushings)
Replaced lower control arm now way out of alignment???
heated seat thermistor
How to test temperature sender?
Hydraulic lifters and how to test 'em better?
New Rabbit! New to the boards! New leak!
Steering just a bit too loosey goosey
Temperature light flashing
oil pressure drops in sharp turns?
High speed vibrations, you tell me why
it's alive but smokey
Another non-start thread, no fuel in injector return lines
My no start issue, LOW COMPRESSION!!!!!! New diagnosis!!!!!!
It never ends, now the injector returns are leaking.
Starting issue
trying to put ammeter on vanagon