View full version: IDI Engine
  1. removing vacuum pump
  2. Tore the head down finally
  3. blue ring seals on inlet manifold gasket, where should it touch?
  4. camshaft belt tensioner locknut torque is 33 ft lbs???
  5. true or false?
  6. Ultra Low Sulfur
  7. OOPS POO BOX build..
  8. Adjusting valves
  9. a wooden timing plug tool
  10. Stiff/stuck cold start advance lever
  11. WVO/WMO filter plan
  12. Help Changing coolant
  13. Found .020 longer valves (OAL) in my head?
  14. stock 1.6td only seeing 5-7 PSI
  15. Does the motor mount have to come off first to remove turbo drain line?
  16. TTY head bolt and block hole prep
  17. How to clean block deck?
  18. Forcing air into my 1.6 NA then going into a MK3
  19. Porting 1.6 head to suit PD intake
  20. 1.8L to 1.9TD swap
  21. what do you guys think of this Caddy
  22. pulling injection pump shaft seal
  23. C clip on IP advance lever
  24. How do you remove the throttle thing on AAZ pump?
  25. VNT control design problem
  26. Deleting A/C
  27. I want to put a serpentine belt drive on my 1992 Jetta Ecodiesel with A/C
  28. Possible VNT actuator?
  29. Them thar rubber flappers
  30. Is this bad?
  31. Glow plug overide switch
  32. 1.6 TD rebuild questions
  33. Intercooler for MK2 A/C car
  34. loud noise and loss of power?
  35. 1.6 NA and 1.9 TD.. few questions.
  36. Residual Fuel Delivery Adjusting Screw, Checking and Adjusting.
  37. GTD pics
  38. Towing
  39. Where to get a gasket set for AAZ injection pump ?
  40. valve spring compressor
  41. AAZ head missing integral pieces ??
  42. A question for those with prothe cylinder head experience
  43. Is this 1.6td setup right?
  44. oil pump for aaz vanagon conversion
  45. vane control
  46. measured piston protrusions with dial gauge indicator
  47. black smoke on an AAZ without turbo
  48. Are Prothe engine gasket set ok to use?
  49. Which head gasket and bolts?
  50. 1.6 TD fixins on an AAZ longblock