VWDiesel.net The IDI, TDI, and mTDI source.
General Information => Troubleshooting => Topic started by: wolf_walker on April 21, 2014, 10:58:15 pm
-
Anyone have one of these handy? I need the offset and length of the flat part.
(http://i59.tinypic.com/69gvu9.jpg)
Sent from my SCH-I545 using Tapatalk
-
(https://dl.dropboxusercontent.com/s/sgkkcvueaf9sc2c/offsetLink.png)
The 11mm hole is an estimate, since the plastic grommet is still installed.
https://www.dropbox.com/s/uz6t1p4bos5chp6/offsetLink.stp
-
Beautiful, thank you sir!
Sent from my SCH-I545 using Tapatalk
-
Wonder why my aftermarket one I dug up is a 47mm offset? Length matches at 132 after bending my stock one to match. It's a 35 degree angle, figured that wasn't coincidence.
Sent from my SCH-I545 using Tapatalk
-
Hmmm... the one in your picture (in the vise) looks like a welded assembly. The one I measured (1991 ECO Jetta) is fastened to the vertical shaft by the rectangular hole and a nut.
-
That may well be it, this one is way old, hell it could be from a 4spd originally for all I remember.
I had a chrome aftermarket short shifter I dug up and bent it to match, guess I'll try it and see.
It actually shifted fine like it was so there must be some margin for error. I suspect the goal is
to have that arm that attaches to it level with the ground when installed.