View full version: IDI Engine
  1. ARP Studs (11 mm) Torque confusion
  2. Head questions
  3. ...............
  4. 1.6 na exhaust replace
  5. Port/Polish brand new head
  6. car running cooler after cetane addatives?
  7. grit for ball hone
  8. HOW is it possible for these to flow any better than a stock TD piece?
  9. r&r heater core 81 caddy tricks?
  10. Engine dimensions
  11. Removing and replacing valve stem seals
  12. What is the purpose of this part on the diaphram vacuum pump?
  13. Oil System Upgrade
  14. 5 Speed Gas 1.7 Tranny in a 1.6 Diesel
  15. 1.9TD pump on a 1.6TD
  16. Accelerator question
  17. GT2056V on a 1.6TD...
  18. AAZ 'split-ring' IP
  19. aiming for 180hp+ with AAZ...
  20. Poll: Roll Starting After Rebuild?
  21. Where is my oil going?
  22. Rear triangle injection pump thing.... leaks
  23. 1.6 Rebuild Questions - Almost There!
  24. 1.9 head on a 1.6td block or variations
  25. 11mm versus 12mm
  26. Adding a pulley??
  27. Couple swap issues that need to be resolved..
  28. 11 mm Head bolt woes; go to studs?
  29. Crank Stud??
  30. Serpentine Belt Length
  31. Where to buy turbo gaskets
  32. Main pump head seal size
  33. 1.6 pump differences
  34. Help i.d.-ing this part
  35. injector spray pattern?
  36. Pistons for AAZ - .020 over
  37. N/A pump mod for this setup??
  38. Vacuum lines?
  39. Adding A/C compatibility with gasser parts
  40. Almost There!! It Runs!! :) and hemorrhages fuel :(
  41. Swap, Alternator won't excite.
  42. pump advance to much?
  43. oil color
  44. New member - Volvo 2.4 TD
  45. exhaust studs keep braking
  46. oversize piston pins?
  47. Injection pump problems.
  48. 81 Caddy steering column clunk
  49. 81 caddy 1.6 questions
  50. Which injection pipes for a franken 1.6/1.9 engine?