Hello everyone.
I've spent the last year swapping a 1.6TD JX into my 1981 VW Vanagon (replacing a broken 1.7KY NA Motor). I've swapped everything from a donor vehicle that I test drove shortly before removing the motor and transmission. In the process I replaced most the seals and sensors (aside from the head gasket and injector pump).
It's now finally in my bus, cranks and starts with the cold start pulled all the way out. When I give it gas or push the cold start back in it sputters and dies. Here's what I've checked so far:
- Set the belt timing to TDC
- Set the injection pump timing to 0.9
- Bled the injector lines
- Fed fuel directly into the injector from a clean container to bypass the filter and make sure it wasn't a filter problem
- Checked for power at the solenoid and glow plugs - yes
I have photos and video of the following but can't post them to the forum. I'll update the thread if I get permission.
- A photo of the injector pump timing set to 0.9.
- A video of the engine running and (you can't see it) but I push the cold start cable in and it stalls out. Please ignore the unfortunately timed air compressor turning on right at the end. You'll also hear my garage mate spraying the compressed air in the background (that's not my motor!)
- a video of it running roughly and you can see the bypassed fuel system. Is it curious no fuel is coming out of the return line?
Only thing I can think of is to advance the pump timing but I don't really want to move it forward from the recommended settings until I've exhausted everything else. Thanks in advance for your help!
Recent Posts
