Author Topic: Need 1.6 l TD piston/rods (Read 3940 times)

glichter1 · « **on:** July 14, 2007, 03:33:52 am »

need standard 76.5 mm TD pistons/rods set of 4- jumped timing took out half the motor, not sure if i can use N/A rods, i have my old N/a motor but read somewhere that the pin clearance on the TD rods was greater?

Peter · « **Reply #1 on:** July 23, 2007, 11:34:49 am »

Quote from: "glichter1"

need standard 76.5 mm TD pistons/rods set of 4- jumped timing took out half the motor, not sure if i can use N/A rods, i have my old N/a motor but read somewhere that the pin clearance on the TD rods was greater?

..I have a bottom end 1.6TD for sale sitting in the garage..perhaps more importantly, where do you live?? I am around the Port Huron Michigan/Sarnia Ont area

Patrick · « **Reply #2 on:** July 24, 2007, 06:12:58 am »

And I'm about an hour from him. Others are scattered around too, so where are you?

Peter · « **Reply #3 on:** July 24, 2007, 09:48:51 am »

Quote from: "Patrick"

And I'm about an hour from him. Others are scattered around too, so where are you?

... Sarnia

burn_your_money · « **Reply #4 on:** July 24, 2007, 11:42:41 pm »

Well that's just handy. You should add that to your profile, I won't bother with what I have

Peter · « **Reply #5 on:** July 25, 2007, 07:03:30 am »

Quote from: "burn_your_money"

Well that's just handy. You should add that to your profile, I won't bother with what I have

Done