Metal Head Gasket Torque Figs? - IDI Engine - VWDiesel.net The IDI, TDI, and mTDI source.

• Metal Head Gasket Torque Figs? by duffer on 20 Apr, 2007 06:53
• When installing the 1.9 metal head gasket
  
    on a 1.6 TD, do I use the same torque
  
    figures as for the normal head gasket?
  
    Or are the torque numbers/proceedure
  
    different?
  
    Any information greatly appreciated.
• #1 by mdonau on 20 Apr, 2007 13:09
• hi..
  
  -normally- the procedure is: 30nm, 60nm, 2x90° -> thats all
  otherwise contact the gaskets manufacturer for instrucktions, if not delivered with the gasket.
  
  greets, Michael
• #2 by duffer on 21 Apr, 2007 16:15
• Thank you for the information.
  
    Someone, on another forum, was
  
    puzzling over this. So, I thought I'd
  
    ask those who have done this upgrade.
  
    Thanks again.