Have you checked local engine rebuilding maching shops? That's where I found the cleveite sets. Local and the best price I can find. Walk in with a part number.
Quote from: Mr Brick-YardInterestingly the box pictured above has the parts marked as a Cam Bearing? Which, I suppose it is, sort of.It has a cam lobe to run the mechanical fuel pump on carb gas rabbit... :roll: Andrew
Interestingly the box pictured above has the parts marked as a Cam Bearing? Which, I suppose it is, sort of.
Here are my two Intermediate shaft installation and removal tools. I had them made up by a machinist friend of mine. The larger diameter needs to be slightly less than the outside of the bearing and the smaller diameter portion needs to be slightly smaller than the inside of the bearing. There needs to be two as the bearings are different sizes. The all thread threads into the center part of the tool and is long enough to extend out of the block. A piece of flat with a hole in it along with another 3 nuts on the end of the shaft are used. Two of the three nuts are just locked together on the all thread and used to hold the all thread from turning. The other nut is turned against the plate with the hole it it to pull the tool and the bearings out and in. The tool can be used to remove and replace the bearings at the same time.Andrew
The parts interchange number for Federal Mogul is listed on the pic of the Dura-bond bearings:1726M is the Federal Mogul one.Andrew