Gear Oil recommendations

[monst]

       I can't believe how clean the inside of this transaxle is.
300k.......     I would like to put in new gear oil, being that
I drained out the old due to installing new clutch etc. etc.
What is the general consensus recommendation on  gear oil.. Brands... and Visco.....
         It's a 92 with the fivespeed...

thanks, Monst

[sgnimj96]

Valvoline Syncromesh unless you live somewhere super hot or race it.

[srgtlord]

Personally I use sta-lube 85w-90 from NAPA because it comes in a gallon container and is GL-4 rated. I live in newengland and during the winter I let the car warm up awhile before driving anywhere

[monst]

Thanks!

  I can look it up but, does anyone know off hand..
Transaxle   Capacity.......

[ORCoaster]

I think it depends on your transmission.  Best to look it up.  I think I bought two quarts a bit ago and used maybe 1.5?  Not sure but the Valvoline brand came in these nice foldable packages.  Nice for use in a tight spot. 

[monst]

Thanks!
        Hard to find stuff at the moment.....
We'll have to see what I get on the lube.... got NAPA around here soooo..... might be NAPA
Try tomorrow some more.... for some Redline....

[fatmobile]

 Lot of people used to recommend Redline MTL.
 Make sure your flange seals are good.
I remember a friend filling his trany and having that red stuff run right out the flange seals and onto the floor.

[monst]

Yeah, I can see that with the MTL....... it is a little thinner....

   I think I have some   MT-90  I can get tomorrow.....(that is what they said) actually two places.
 
Yeah, Had the tranny out so  installed  drive flange seals....    Did all the seals..
Hoping for a leak proof scenario....  Get this puppy running again.....

[srgtlord]

If you ever have trouble with the hockey puck seals on the transmission permatex 2a works wonders for keeping them in place

[monst]

GTK.....  Yeah, I heard that they can sometimes leak.....
Yeah, tranny is all sealed up with new seals. I cleaned off
all the grunge, hopefully it stays that way. I can better see
where problem leaks are now(and hopefully there are none/less)....
     I didn't put on a new oil pan gasket. I did a new
valve cover gasket and did a new seal on the vacuum pump.
I just have to throw on some tires and lower it. I ran it to
operating temps  twice now(up on the jack stands) she
seems pretty happy, though I have to get a new exhaust flange
made.... So at the moment I am running an open exhaust(somewhat).

[fatmobile]

 The rubber valve and oil pan gaskets from a 2.0 ABA block are a nice upgrade to the cork and pieces valve cover gasket.

[monst]

That is good to know thanks!
  Yeah, cork is Passe.

[monst]

Car shifts beautifully.
(new clutch)
I bought some sorta kit and replaced some parts of the shift linkage.
296K  car is tight.  I just gotta get the exhaust tied in. I have been
running it with open exhaust, be nice to hear other thingzzzz...

But, she has a new lease on life...

BTW: I have two Jettas...(but only one hood!)
Thanks!

[Ohiobenz]

I've used Lucas synthetic for the last several years and am happy with it.  NAPA carries it.

[rabbitman]

I run a mix of redline MTL and MT-90 due to something I read on here years ago. It works good, very thin and at -40 it shifts like butter. It used to stall at -30 with dino 75w-90.