I would like to do some improvements to my Mk2 Jetta interior, starting with the front seats. Preferably finding some with more side support. I have had them out and my do they have unique mount just a bolt at the front and the rear sliders fit into the chassis. Has anyone updated their seats? What did you use. I am pretty sure I could cut the base off of the standard seat and weld or make a platform but a fit with minimum changes would be better.
I literally breathed new life into my motor. Was doing service under the hood and found that mice had built a nest in the bottom half of the airbox. It actually ran ok the way it was. but seems to run with less throttle now and is quieter.
Thanks
Dave
As TylerDurden said, Mk2 Recaros are the bomb! I put a pair in my Caddy, and they are just wonderful.
You can take seats from any Mk2, or if you fancy a little welding, any Mk3. The Mk3 sliders are like 1.5-2" wider than the Mk2, but otherwise the same.
Before
After
I used some seats out of a colbolt that was wreaked with very low mileage so the seats are brand new and have all the functions I needed. My cars a coupe so I wanted to have the easy access buttons and lumbar and easier seat adjustment.
Had to make a special mounting bracket but was less than 20 bucks for two plates from local fab shop.
My brother is a vw purist type and he hated seeing me not use recaros but these are new not from the 80s and they really updated the look inside.
Sent from my iPhone using Tapatalk
Nice upgrade, If you plan on a long distance drive anytime soon those will make it all the better. Would not have thought to cross over to another vehicle like that. Nice to know it can be done. At least in the older VW's. I doubt it would work in my Caddy. Just no room for much else with the back of the cab so close. I am tall so leg room is a premium in the truck as it is.