FS: Cylinder Head clear-out 1.6NA 1.6TD AAZ * 50% OFF * - Parts for Sale/Wanted - VWDiesel.net The IDI, TDI, and mTDI source.

• FS: Cylinder Head clear-out 1.6NA 1.6TD AAZ * 50% OFF * by burn_your_money on 18 Nov, 2013 17:35
• Shipping a head to the USA is $75.
  
  Some of these heads have been sitting on my shelf for a while. I don't know the condition of any of the lifters.
  
  Head #1
  1.6TD - 0.003" warpage. 2 of the injector bosses have been repaired in the past $100
  
  
  
  Head #2
  1.6TD 0.004" warpage. One cracked injector boss, no lifters or cam $40
  
  
  Head #3 SOLD
  1.6NA 0.003" warpage NO CRACKS between valves. 2 precups have very small cracks. I tried to get a picture of the larger of the two $120
  
  
  Head #4 SOLD
  AAZ 0.003" warpage. The head isn't fully cleaned so the warpage may be less. NO CRACKS between valves. At least 2 valves are bent. No lifter bore damage. Cam shows some wear. Likely has 7mm valves $150
  
  
  Head #5
  AAZ 0.008" warpage. Likely has 8mm valves. good for parts for above AAZ head (just swap valve guides to convert 7 to 8mm) - $60 - will part out
  
• #1 by burn_your_money on 17 Dec, 2013 18:44
• Make offers, I don't want to move these again
• #2 by vwzzuk on 19 Dec, 2013 11:53
• Sent you a PM.
• #3 by burn_your_money on 30 Dec, 2013 08:32
• 1 gone, 4 to go. Step right up 
• #4 by spencebm on 30 Dec, 2013 09:15
• Somebody throw some money at this guy!  He is getting married!
• #5 by vwzzuk on 06 Jan, 2014 23:23
• Thanks. Got it today!
• #6 by secondgen on 17 Jan, 2014 14:16
• Would the .003 AAZ head be useable if all the guides and valves were replaced? I don't know off-hand what the "acceptable" warpage is on a diesel head.
• #7 by burn_your_money on 21 Mar, 2014 13:39
• Quote from: secondgen on 17 Jan, 2014 14:16

  Would the .003 AAZ head be useable if all the guides and valves were replaced? I don't know off-hand what the "acceptable" warpage is on a diesel head.
  

  
  0.004" is the maximum allowable warpage so technically it's fine, but I would have it machined (should cost $50-$100)
  
  EVERYTHING IS 50% OFF
• #8 by Kazuki on 21 Apr, 2014 20:49
• Hey i would like to buy head #1
  ^.^
• #9 by njdub on 23 Apr, 2014 20:47
• Sent pm.