Hi guys, I recently sold my MK1 rabbit. I have a few parts I would like to sell off.
Body PartsExtra Clipper Kit hardwareMiscellaneous left over, extra hardware from my clipper kit install on my mk1 4 door hatch.
$1 - you pay ship
Flag MirrorFlag mirror. This is not an OE part, it is aftermarket. Koolview.
$5 plus shipping
Engine Parts1.5D or 1.6D (Diesel) InjectorsNot much else to say. These were functioning upon removal. I was netting about 42 mpg on a worn out <270psi comp tested engine. Good for cores/rebuild.
$30 shipped.
AAZ InjectorsInjectors that fit the AAZ motor, 1.9 Turbo IDI. These injectors are not operational, they need rebuilt.
$50 shipped.
AAZ A/C Idle Increase Vacuum DiaphragmNot sure if it works, mounts on the AAZ injection pump
$1 - you pay shipping
Alternator Pigtail V-Belt Alt setup Mk1This is for the old V-belt alternators. It is a bit dirty, but the wire insulation is not cracked at the plug.
$10 shipped.
Cast Iron Alt BracketNon AC cast iron alternator bracket.
Bracket w/hardware: 068903148 (i believe, have a look for yourself)
Tensioner Arm: 068903253F
$80 plus shipping.
Coolant Outlet FlangeCoolant outlet flange on the head. It is the one on the front of the head. This one is cast aluminum. New ones are plastic. Came off 1.5D
$5 - plus shipping.
Coolant PipeThis came off my 1.5D, I was going to put it on my AAZ and consequently would eliminate the oil/water sandwich adapter for an air oil cooler. Not bent, decent condition.
$5 plus shipping. (expect shipping to be $30 because of size and fragility)
1.5D Engine/Pump BracketCame off a 1.5D engine. Bracket is in good condition, was well coated in oil, diesel and grease (LOL).
$40 + $25 shipping
Mount InsertTrans mount insert. If trans mount is purchased (in other thread) then this will go with it.
$1 + ship
AAZ Exhaust BracketExhaust bracket, I think this came off an AAZ. I was unable to use this part because I had to reqork the exhaust to fit the AAZ in my mk1 rabbit.
$1 - you pay shipping
Head Water OutletThis is the water outlet flange that comes off the end of the head. From an AAZ
$1 + shipping
1.5D (or 1.6D?) Injection LinesInjection pump hard lines from 1.5D
$20 + shipping
Gasser Intake ManifoldIntake manifold from an mk1 gasser found at a junkyard.
Part number looks like 049 133 223
$40 + 25 shipping
IM Shaft PulleyIntermediate shaft pulley from a 1.5D. Not sure if this will fit other diesel engines, my thinking would be thast it will work with other IDI's.
$5 + shipping
Main Oil FlangeGood condition.
$12 shipped
Oil Filter BracketOil filter bracket from 1.5D Looks like it is in good condition.
$15 + shipping.
Power Steering Pump BracketPower Steering pump bracket, if you want the pump as well let me know, but I doubt it works.
$10 + shipping
Belt Tensioner ArmThis is for the tensioner pulley. I am not sure what this one goes to, because it was incorrect one for my AAZ. There were two version. Maybe this was for Non-AC models. Brand new
$10 + ship
Throttle Cable BracketThrottle cable mount at the pump. I think this came off an AAZ pump
$5 + ship
Lower T-Belt Cover 1.5DLower timing belt cover from my 1.5D engine.
$5 + shipping
Cam SprocketWas removed from 1.5D engine. Not sure if they are the same across the board.
$5 + shipping
Trans Parts100mm Axle FlangesFor 020 transmission.
$60 + ship
Shifter mechanismNot sure if it is 4 speed or for 5 speed, or if it even matters.
$5 plus ship
Strange trans bracket pieceProbably to linkage.
$1 - plus shipping, or $5 shipped.
Trans Dust ShieldDust shield, top half, goes between trans and engine. Came from an AAZ engine. I don't believe the lower half of the shield is manufactured anymore.
$10 - plus shipping.
Trans Mount Mk2I believe this is an MK2 trans mount. It came off my ASF trans. Came from a 92 Jetta 1.6D
$20 - plus ship
Thanks for looking,
Eric
