Diesel injector lines - Troubleshooting - VWDiesel.net The IDI, TDI, and mTDI source.

• Diesel injector lines by shwartzbewithyou on 20 Mar, 2006 07:02
• I replaced 2 of my injector lines this weekend and noticed that the original lines have a waaayyy smaller I/D than the lines that I used. I think this may be affecting my injection timing on cylinder's #3 and #4. I just got bulk steel tubing to change them out.
  
  Question: Is their specific tubing I should be using for injector lines?  The original had a realllly thick side wall.
• #1 by BlackTieTD on 20 Mar, 2006 07:12
• you'll want to use the original lines. dealer probably has them, if not the junkyard will... or an aftermarket supplier. put up a want ad i'm sure someone has a used set.
• #2 by shwartzbewithyou on 20 Mar, 2006 11:06
• I can't find any online vendors that list them.  Ugh I don't want to have to go to the dealer.
• #3 by wyldman on 20 Mar, 2006 11:12
• Try ebay,I've seen a few sets on there for sale.
  
  I have some here,but they are kinda needed to go back on motors once they are rebuilt.If your stuck,I could lend you a set until you find some.
• #4 by shwartzbewithyou on 20 Mar, 2006 11:16
• Quote from: "wyldman"

  Try ebay,I've seen a few sets on there for sale.
  
  I have some here,but they are kinda needed to go back on motors once they are rebuilt.If your stuck,I could lend you a set until you find some.

  
  
  That may actually be a good idea because I'm not going to get a chance to go the the wrecker this weekend and they're not open by the time I get off of work in Mississauga and get home to Hamilton.  Plus I'm afraid it may hurt my injector pump if I don't get it done soon.
  
  I'll PM you.
  
  Thanks