FS: 80 Caddy, 81 Gas Rabbit 2dr -Picture Heavy- - Parts for Sale/Wanted - VWDiesel.net The IDI, TDI, and mTDI source.

• FS: 80 Caddy, 81 Gas Rabbit 2dr -Picture Heavy- by camboscams on 19 Jun, 2011 16:09
• So here it is, theres so much stuff here if you see anything that strikes your fancy let me know. If you want either the car or the caddy i'm willing to sell as a whole.
  
  The car: Its a gasser i've never run it. the interior is rough but the body is pretty straight. if you want more pictures just pm me
  The caddy: its got a broken camshaft thanks to the previous owner attempting to tighten the camshaft bolt without the proper tool.
  
  There are tons of NA 1.6 and some 1.5 parts as well, i know thats vague so i apologize
  
  If you want any more information or pictures just let me know!
  
   
  
  
  
  
  
  
  
  
  
  
  
  
  
  
  Thanks, Cambo
  
• #1 by camboscams on 24 Jun, 2011 04:33
• Im not looking to get rich here and i know i didn't include prices, but i'm pretty much trying to get out from under the title transfer costs from when i bought it so make me any offer
• #2 by 79rabbit4dr on 29 Jun, 2011 22:31
• Quote from: camboscams on 19 Jun, 2011 16:09

  
  

  
    the tailgate (even all rusted) and the tail light assemblies are the only things I see worth keeping/selling. The rest I'd take to the metal recyclers, honestly.
• #3 by R.O.R-2.0 on 30 Jun, 2011 09:15
• pull that mk2 pump off the truck before you get rid of it..
  
  i really wish i had a mk2 pump, for the out bolt pedestal..
• #4 by camboscams on 30 Jun, 2011 09:43
• yea that might be its next stop unless no one here shows any interest.
  

  Quote from: R.O.R-2.0 on 30 Jun, 2011 09:15

  pull that mk2 pump off the truck before you get rid of it.. i really wish i had a mk2 pump, for the out bolt pedestal..
  

  
  if you want it let me know and i can look up some shipping numbers
• #5 by ORCoaster on 30 Jun, 2011 21:29
• R.O.R.  for the grand sum of about 2 bucks you can make that out bolt extension yourself.  One nut and bolt from the hardware store.  12mm 1.25 pitch I think.  Drill the bolt down the center and solder the nut on the top.  Works fine.  See here:
  
  
  
  I had to use thicker copper washers on either side of the OUT bolt to get it to seal tight.  The OUT bolt was bottoming out in the nut and I didn't want to file off the bolt as it has the screen in it.  So far this little bugger is working well to monitor the IP pressure. 
  
  
• #6 by R.O.R-2.0 on 01 Jul, 2011 10:23
• well, if Cambo doesnt want much for the whole pump, i will go that route.. you can never have enough pumps..
• #7 by ORCoaster on 01 Jul, 2011 20:20
• true dat