its done,the well is gone
actually the whole back end is done :lol:
the tire well is gone
i just cut the sides off the tire well and rewelded it back in
and i cut out the rear valance
and recently i took the little rear fender corners off,cause i thought they looked silly hanging down with no rear valance
the aero effect of no valance is quite noticible,not as draggy
for people that dont wanna cut+chop,build a belly pan
there was a little bit of trickery as you cut around the front of the tire well,just cut around the crossmember to keep it as a boxed section
this stuff cuts off so easy with a plasma cutter
heres "raw"
and here it is with spray on truck bed liner
page 2 owned