Howdy all,
I just got my injectors back from Smog... recalibrated with GTD nozzles. What torque to I use when I put them in?
52 ft-lbs.
And also do yourself a favor... buy a Bentley manual.
Thanks Jake... I do own one, I just don't have it. Loaned it out and never got it back.
Make sure the threads inside the head are cleaned out properly. The first time I changed out my injectors, I didn't make sure that the threads were cleaned properly, and I snapped the corner of the head off! I never even got to the torque spec. So becareful!
Howdy all,
I just got my injectors back from Smog... recalibrated with GTD nozzles. What torque to I use when I put them in?
remember to replace your heat shields
Thanks everyone... yup I cleaned teh threads and replaced the heat sheilds.
Question... what sockets do you guy use? The 3rd injector (from teh flywheel) was impossible to get a socket around... the IP was too close. I had to use a wrench and bad language. In the futur, is there a special socket to do this?
i normally use a thin wall 1/2 drive socket with a 6 inch extension, i think its a 27mm. usually i have to put the socket on first before connecting the wratchet and extension.