Author Topic: 2002 Passat seats into a MKII Golf?? (Read 3333 times)

mtnbob · « **on:** July 21, 2008, 01:56:06 pm »

Is it feasible??
Just wondering.

zukgod1 · « **Reply #1 on:** July 21, 2008, 04:32:59 pm »

ANYTHING is feasible.

I've seen it done so go for it.
Would like to do the same thing myself.

gigaz2 · « **Reply #2 on:** July 21, 2008, 04:53:09 pm »

cut and weld job as the rails have a different width on one side and the center section is completely different.

a mk3 golf only differs on the rail width, so its easier, you only have to cut one leg off the old mk2 seats and weld it on the mk3 ones.

mtnbob · « **Reply #3 on:** July 22, 2008, 02:08:09 am »

There are some nice black leather Passat front seats on ebay right now for $175. Shipping was $150 from Ohio to South Carolina. I'm going to pass, if I have to cut and weld to make them fit. I was told that Corrado seats are a simple bolt-in, so I guess I'll keep looking.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=350079776987&ssPageName=ADME:X:RTQ:MOTORS:1123

Ziptar · « **Reply #4 on:** July 22, 2008, 07:08:15 am »

There is a good DIY on the vortex for swapping MKIII seats into an MKII, B4 Passats may not be that different, I think they are wider though. Some info on the rear seats here and here, again a B4 Passat is going to be wider than an MKII.

gigaz2 · « **Reply #5 on:** July 22, 2008, 10:05:09 am »

thanks for the links Ziptar, I am planning something like this and they sure help

zukgod1 · « **Reply #6 on:** July 22, 2008, 11:17:08 am »

Quote from: "mtnbob"

There are some nice black leather Passat front seats on ebay right now for $175. Shipping was $150 from Ohio to South Carolina. I'm going to pass, if I have to cut and weld to make them fit. I was told that Corrado seats are a simple bolt-in, so I guess I'll keep looking.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=350079776987&ssPageName=ADME:X:RTQ:MOTORS:1123

Those are nice seats but you can get them for less money.