Author Topic: WTB K24 turbo, or = for 1.6 td, ex. manifold rect. flanged (Read 3686 times)

Familydiesel · « **on:** August 20, 2008, 07:46:53 pm »

I want to buy a good K14 or K24 turbo, or a turbo that has a trapezoid shaped exhaust inlet flange. I have the square (8cm X 8cm) exhast flanged down pipe and want to get a turbo that will bolt up to this 85 Jetta 1.6 td engine setup.
Or
I Would consider a good T3 (retangular flanged) exhaust manifold that fits the 1.6td.
Thanks,

Greg

westyman · « **Reply #1 on:** August 21, 2008, 01:53:51 am »

I have a K24 that had the wastegate actuator removed, valve blocked in the closed position, runs a nice 24 psi wide open on a TD. :-)
Had it on a TD Vanagon.

Familydiesel · « **Reply #2 on:** August 22, 2008, 10:20:58 pm »

Hey Westyman,
Check your pm.
How much do you want for the turbo? Is it tight without end play or does it need a rebuild?
I have other questions, but I wrote them on a pm.
Thanks,
Greg

Familydiesel · « **Reply #3 on:** September 25, 2008, 08:13:29 pm »

Hi,
I bought a K14 from blkboostedtruck.
Thanks,

Greg

burn_your_money · « **Reply #4 on:** September 25, 2008, 08:23:35 pm »

for future reference, the VW diesel T3 uses the same flanges as the K14 and K24, amongst others

Author Topic: WTB K24 turbo, or = for 1.6 td, ex. manifold rect. flanged (Read 3686 times)

westyman