Jake's KKK K24 Rebuild - restored

[Darkness_is_spreading]

Hey I need to know the exact bolt size for the exhaust side bolts that connect the casting to the cartridge. I measured them and they were spot on to 8mm, I picked up some bolts that are under grade 8 strength.  

I think I need to re-tap the holes, and try again but if anyone can confirm that they are 8 mm that would be great.

I will post picks of the Hybrid Turbo build.

[starrd]

Hey I need to know the exact bolt size for the exhaust side bolts that connect the casting to the cartridge. I measured them and they were spot on to 8mm, I picked up some bolts that are under grade 8 strength.  

I think I need to re-tap the holes, and try again but if anyone can confirm that they are 8 mm that would be great.

I will post picks of the Hybrid Turbo build.

I will measure a spare one tonight if you like and I will post the info back here.

OK - for K24 the 6 bolts are 8mm x 1.25 pitch x 16mm long

[Darkness_is_spreading]

Thank you sir, I needed that info as I cannot locate the original bolts.   Had to re tap all the holes tonight, will take some pics, and build it tomorrow.

[R.O.R-2.0]

great write up.. should be put in a FAQ or something..

[CrazyAndy]

great write up.. should be put in a FAQ or something..

x2!  Actually just mentioned and relinked to this in my build direction query thread.

[theman53]

Jackpot. That is the link I was telling you about in the other thread, I used it for reference whenever I put my wastegate back on my turbo.

[oblique]

Pics are down...any way to resurrect?