Connecting oil temp guage

[wikdslo]

I just finished intsalling a volt guage and an oil pressure guage (5 bar) and am wondering about where I can get the signal for the oil temp guage.

I know there are 3 senders on the side of the block (1 now that I replaced the top one with the oil sending unit, but I was wondering where I can get this reading from?

Is there already a sending unit on the motor?
If so, will disconnecting the stock wiring harness wire cause me any problems?

1.6na Rabbit.

Thanks folks

[Vincent Waldon]

As luck would have it, there's a rousing conversation goin' on over here on this topic:

http://www.vwdieselparts.com/forum/viewtopic.php?t=7697&sid=13ae5f22d1534c5197bcf4dd4a4781a2