« previous next »
Pages: [1]

Author Topic: bending injection lines  (Read 5408 times)

January 18, 2008, 09:03:53 am

jimfoo

  • Veteran
  • Offline
  • ***
  • 2110
    • http://www.66rover.com
bending injection lines
« on: January 18, 2008, 09:03:53 am »
Ok, I know you aren't supposed to do it, but who has, and who has had problems afterwards? ALH lines are plentiful, AHUs are not, which is what I need. While I can see tight bends causing problems, I really don't see how a gentle bend could do anything.
Logged
Jim
1966 Land-Rover 88" with 1.9 1Z which has been transformed to an M-TDI
TFO35 mechanically controlled VNT, IC , and 2.5" exhaust.
Driven daily
Reply #1January 18, 2008, 03:03:07 pm

jtanguay

  • Veteran
  • Offline
  • ***
  • 6879
bending injection lines
« Reply #1 on: January 18, 2008, 03:03:07 pm »
i would imagine there to be a 'coating' if waste veg was used constantly and then no purge  :lol:.  i would heat the metal before bending though...

as long as the injector lines retain the same length you should be fine.
Logged


This is how we deal with porn spammers! You've been warned.
Pages: [1]
« previous next »